ECU & Module Repair
ECU / TCU Cloning
Transfer of original engine or gearbox control-unit data to a compatible replacement ECU or TCU.
Before contacting us
Send the exact details.
Vehicle model and year, module label or system version and fault codes or the requested work.
When you need this service
- You have a faulty ECU or TCU and a replacement unit.
- You need the replacement unit matched to the vehicle’s original data.
What we do
- Compatibility check of original and replacement units
- Transfer of recoverable immobilizer, VIN and adaptation data
- Checks and programming requirements for installation
Provide both unit labels and describe the fault. The result depends on compatible hardware and readable original data; vehicle adaptation may still be required.
Cloning, programming & recovery
The exact controller and recoverable original data determine the right operation. A similar-looking donor is not automatically compatible.
What data can be transferred?
Supported flash, EEPROM, coding, calibration, VIN and immobilizer-related data may be transferred to a compatible ECU, ECM, PCM, DME or DDE. A read does not necessarily include every memory area; coverage is checked for the exact controller.
TCU, EGS & DSG replacement
Send the gearbox code and photos of both controller labels. Compatible automatic-transmission and mechatronic units may support data transfer. Coding, basic settings or adaptation may still be required after installation.
Cloning or replacement programming?
A complete supported clone may allow direct replacement. Other controllers need software programming and vehicle-specific setup instead. We check part numbers, hardware, software and the condition of the original data before confirming the work.
Interrupted programming & ECU recovery
Recovery may be possible through a supported bench or boot method after a failed write. No communication can also result from power, wiring or damaged electronics, so recovery and hardware repair are assessed separately.
OBD, bench or boot?
OBD uses the vehicle diagnostic connection. Bench access connects to a removed controller through its connectors. Boot access may require opening the unit. The supported protocol and controller condition determine the method.
How the service works
1. Identify — send vehicle details, symptoms, diagnostic codes and both module labels.
2. Assess — we check donor compatibility and the available read/write method.
3. Transfer — recoverable original data is backed up and transferred where supported.
4. Verify — results are checked and required vehicle-side setup is explained.
Frequently asked questions
Can a completely dead module be cloned?
Not always. The necessary original data must be recoverable and the replacement compatible. Tell us whether the original still communicates before buying a donor.
Does cloning repair a hardware fault?
Cloning transfers data. It does not repair damaged electronics or unrelated wiring, engine or gearbox faults.
Is cloning the same as tuning?
No. Cloning supports module replacement; tuning changes the calibration for a different purpose.
Discuss your service.
Send the vehicle details, a module-label photo and fault codes if available.
Choose your next step.
Call us or send your vehicle details, symptoms and module reference.
